D3 ACRYLIC PAINT - 20 KG

Shipment within 5 to 7 days 

Description of the semi-thick D3 matt coating based on acrylic resin :

• For exterior use, new or renovation of vertical surfaces of buildings, on prefabricated concrete and derivatives, masonry elements coated with traditional cement mortar or single-coat hydraulic render, facing bricks, bare or coated with old adherent paints in good condition, after suitable fixing.

Strengths of the semi-thick D3 matt coating based on acrylic resin: 

• Masks cracks Impermeable to water run-off
• Good filling properties Good resistance to soiling

Application of the D3 matt semi-thick coating based on acrylic resin:

• Substrates must comply with the relevant DTUs and in particular with NF DTU 59.1 (for decorative systems - D3) and 42.1 (for waterproofing systems - I1).
• Prior recognition is necessary in order to determine the most suitable preparation for their condition and nature.
• Substrates contaminated by moss, algae or fungi must be treated with an anti-cryptogamic solution (algicide and fungicide) in accordance with the manufacturer's instructions, followed by a HP rinse to remove any remaining residues.
• Substrates with saltpetre should be treated by brushing. Where possible, remove the cause of the saltpetre to prevent its recurrence. If snails are present, appropriate measures should be taken to prevent contamination of the facades: backfill with gravel around the perimeter, natural or chemical repellents, etc.
• In general, after preparation, the surfaces must be sound, cohesive, normally absorbent, clean and dry to receive 250g/m² of D3 ACRYL diluted with 10% water before applying 500g/m² of undiluted D3 ACRYL.

• On old, unformed concrete, prefabricated concrete with low absorption or traditional hydraulic coatings or single-coat porous, powdery or old, flaky Pliolites®, after preparation: application of a coat of 180-250g/m² of solvent-based acrylic fixative, before the application of 500g/m² of undiluted D3 ACRYL
• On normally absorbent concrete substrates, hydraulic coatings, bare or coated with old adherent paints in good condition, with little or no chalking: after preparation, apply a coat of 200 to 250g/m² of PROMUREX IMPRESSION, before applying 450-500g/m² of undiluted D3 ACRYL.
• On old single coat scraped renderings, after preparation, apply a coat of 200 to 250g/m² PROMUREX IMPRESSION, before applying 450-500g/m² of undiluted D3 ACRYL.
• On well adhering porcelain stoneware and glass paste surfaces, after preparation, apply a coat of primer before applying 500g/m² of undiluted D3 ACRYL.

yield of the semi-thick D3 matt coating based on acrylic resin :

• 500g/m² / coat 

Packaging of D3 matt semi-thick coating based on acrylic resin :

• 20 kg bucket